Installation Sheet

1of3
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses,markingpen,1/4”
drillbitanddrill.
Contactyouroriginalplaceofpurchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
EstimatedAssemblyTime:
Preparation:
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.
(3)A19Medium Base Bulbs 100W Maximum, Medium Base VintageBulbsarerecommended,bulbsnotincluded.
FixtureHangingHeight:MinimumHangingHeightis13”,MaximumHangingHeightis99”.
Warnings and Cautions
For Style NVG329EK
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
B
Inner Backplate Assembly
x1
A
Ceiling Canopy
x1
Jumper Wires
x1
White Wire
Black Wire
Green Wire
Installation Guide #IS-NVG329EK
2019 QuoizelInc.
ReleasedDate:2019-02-25
visit us on-line at www.quoizel.com
I
Please measure the height you want to hang the pendant prior
to hanging so you know what length to cut the wire. You can add
6" to that length to help adjust the shades up or down once it’s
hung. Please note, all the extra wire will not fit inside the small
canopy and junction box, the wire needs to be cut at the desired
length to fit inside the canopy and junction box to then help
adjust to the exact height.
IMPORTANT: Install the cord into the ceiling canopy before
cutting it to length.
STEP 1 - Install Fixture Bodies to Ceiling Canopy
A. Loosen set screws located on the couplings that are mounted to the
underside of the Ceiling Canopy (B). Do not remove set screws
completely.
B. Place cord through the coupling mounted to the underside of the
Ceiling Canopy (B). Adjust cord to the desired length then tighten
set screw to hold pendant length in place.
C. Install safety clip onto the pendant cords by threading the cord
through one hole then back through the second. Slide safety clip to
approximate 2” from canopy.
D. Repeat these steps for all pendants.
E. After the ceiling canopy is installed to the junction box, a final
adjustment can be made to get the pendants to hang at the desired
height by loosening the set screws on the coupling slightly then re-
tighten when the pendants are adjusted to the desired height.
Cord
F
Set Screw
Coupling
B
Figure 1
H
GND
E
Wire Connectors
x3
F
Safety Clip
x3
D
Screw
x2
C
Wall Anchor
x2
G
Fixture Body
x3
H
Cage
x3

Summary of content (3 pages)