Installation Guide

Bulb Shield

Bulb

FixtureBody

Long Crystal

Short Crystal

Bead String

2015 QuoizelInc.

Oct.2015

CARE AND MAINTENANCE

Wipe clean using soft, dry cloth or static duster. Always avoid using harsh chemicals and abrasives to clean

fixture as they may damage the finish.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Bulbs will not light.

Fuse blows or the

circuit breaker trips

when light is turned

on.

1. Bulb is burned out.

2. Power is off.

3. Faulty wire connection.

4. Faulty switch.

Crossed wires or power wire is

grounding out.

1 . Replace light bulb.

2. Make sure power supply is on.

3. Check wiring.

4. Test or replace the switch.

Check wire connection.

STEP 5:

: Do not touch the bulb with bare hands, as

oil from your skin can damage the bulb; use a soft cloth

or gloves.

IMPORTANT

a. Insert bulbs into fixture sockets.

b. Cover with bulb shields. Hand tighten until snug.

STEP 6:

a. Attach long crystal to the loop in the center of fixture

body at location A.

b. Attach short crystals to the loops at location B

c. Attach the bead string to the loops at location C.

Your installation is now complete! Restore electricity and save this sheet for future reference.