Installation Sheet

Package Contents
Pleasegoto forproductcleaningtips.Gotothe selection.
(1)MediumBaseT9VintageBulb60WMaximum.
www.quoizel.com Care+Maintenance
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
LightSource:
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-DL8406AC_R1
For Style DL8406AC
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
E
B
Mounting
Screw
x2
Inner Backplate
x1
A
Front Glass
Panel
x1
D
Fixture
Body
x1
Figure 2
C
Figure 1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Side Glass
Panel
x2
STEP 1 Install Glass Panels-
A. Insert the bottom edge of Side Glass
Panels (E) into the side slot in the
Fixture Body (C). Fold the tabs in the
topoftheFixtureBody(C)tothetop
edge of the Side Glass Panels (E) to
secure Side Glass Panels (E).
B. Insert the bottom edge of Front Glass
Panels (D) into the front slot in the
Fixture Body (C). Fold the tabs in the
topoftheFixtureBody(C)tothetop
edge of the Front Glass Panels (D) to
secure Front Glass Panels (D).
C
E
D
Slot
Tab
STEP 2 Install Inner Backplate-
A. Pass the supply wires and ground wire through Inner Backplate (A).
Attach the Inner Backplate (A) to the Outlet Box with the head of
Green Ground Screw facing you. Secure it with Outlet Box Screws
(not included). Tighten until snug with screwdrivers.
Outlet Box Screw
(not supplied)
A
Supply Wires and
Ground Wire
Outlet Box
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Figure 3
RevisedDate:2017-12-22