Installation Sheet

1of3
Pleasegoto forproductcleaningtips.Gotothe selection.
Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
MinimumHangingHeightis24.5”,MaximumHangingHeightis115.5”.
MissingParts?Contactyouroriginalplaceof
purchase.
www.quoizel.com Care+Maintenance
ToolsRequired:
LightSource:
FixtureHangingHeight:
(3)A19MediumBaseBulbs100WMaximum,bulbsnotincluded.
EstimatedAssembly Time:
Preparation:
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.
Warnings and Cautions
For Style CKKD2717WT
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Installation Guide #IS-CKKD2717WT
2019 QuoizelInc.
ReleasedDate:2019-03-01
visit us on-line at www.quoizel.com
Package Contents
Crossbar Assembly
x1
A
Ceiling Canopy
x1
B
Wire Connectors
x3
C
Safety Clip
x3
Jumper Wires
x1
White Wire
Black Wire
Green Wire
D
Please measure the height you want to hang the pendant prior
to hanging so you know what length to cut the wire. You can add
6" to that length to help adjust the shades up or down once it’s
hung. Please note, all the extra wire will not fit inside the small
canopy and junction box, the wire needs to be cut at the desired
length to fit inside the canopy and junction box to then help
adjust to the exact height.
IMPORTANT: Install the cord into the ceiling canopy before
cutting it to length.
STEP 1 - Install Fixture Bodies to Ceiling Canopy
A. Loosen set screws located on the couplings that are mounted to the
underside of the Ceiling Canopy (D). Do not remove set screws
completely.
B. Thread pendant cord through the coupling mounted to the underside
of the Ceiling Canopy (D). Adjust cord to the desired length then
tighten set screw to hold pendant length in place.
C. Install Safety Clips (C) onto the pendant cords by threading the cord
through one hole then back through the second. Slide Safety Clips
(C) to approximate 2” from canopy.
D. Repeat these steps for all pendants.
E. After the ceiling canopy is installed to the junction box, a final
adjustment can be made to get the pendants to hang at the desired
height by loosening the set screws on the coupling slightly then re-
tighten when the pendants are adjusted to the desired height.
Figure 1
G
Cord
C
Set Screw
Coupling
D
F
E
Fixture Body
x3
Glass Shade
x3
F
Retainer Ring and
Socket Collar
(Pre-assembled to
the Fixture Body)