Installation Guide

E
E
E
F
F
F
F
F
F
L
L
L
O
O
O
R
R
R
E
E
E
S
S
S
C
C
C
E
E
E
N
N
N
C
C
C
E
E
E
&
&
&
R
R
R
U
U
U
S
S
S
T
T
T
R
R
R
E
E
E
M
M
M
O
O
O
V
V
V
E
E
E
R
R
R
P
P
P
R
R
R
O
O
O
D
D
D
U
U
U
C
C
C
T
T
T
N
N
N
O
O
O
.
.
.
8
8
8
6
6
6
7
7
7
5
5
5
-
-
-
3
3
3
3
3
3
PRODUCT USE:
Removes efflorescence & rust from horizontal and vertical concrete,
pavers, brick, masonry and stucco surfaces
Solvent Free
Low odor
Easy to rinse
Heavy-duty commercial product
SIZES:
• Gallon (3.8 L)
Coverage:
• 100-200 sq. ft. (9.3-18.6 sq. M) per gallon (3.8 L)
APPLICATION
1. WEAR IMPERVIOUS GLOVES, such as nitrile. Protect eyes,
skin and clothes. Wear rubber boots.
2. Sweep and remove all soil and debris from the surface.
3. Dilute product in a plastic container to a 1:4 dilution. Brush or spray
diluted material onto surfaces. Spray carefully. More concentrated
dilutions are possible (1 part Efflorescence & Rust Remover to 3, 2, or
1 part water). Exercise caution especially with more concentrated
dilutions as they may cause etching, particularly when left in contact
for longer times.
4. Allow the material to work for one minute.
5. For heavy efflorescence, scrubbing with a medium to stiff bristled
nylon brush will improve removal. Rinse thoroughly with water.
• Efflorescence & Rust Remover is designed to provide effective and
easy efflorescence removal while protecting against etching when
applied and rinsed appropriately.
• Efflorescence & Rust Remover should be test applied in an
inconspicuous spot in order to optimize the application technique and
to evaluate the effect, before treating the entire area.
PRECAUTIONS
WEAR IMPERVIOUS GLOVES, such as nitrile, which are acid
resistant. Wear safety glasses when handling product. Avoid
prolonged contact with skin or inhalation of vapors. Use with
adequate ventilation. Contains salt of organic acid. Wear rubber boots
to protect feet. Slippery when wet.
• Contact with product may damage clothing.
• Do NOT mix with bleach, cleaners or other chemicals; chemical
reactions may occur and produce poisonous gas.
• PREVENT RUN-OFF. This heavy duty product is not compatible
with lawns and plants. Rinsing with large quantities of water dilutes
the effect. Take appropriate precautions for vertical applications.
• Prevent contact with aluminum and other metals. Protect all non-
concrete surfaces.
• Protect from freezing.
• For walls, take care to prevent dripping or streaking on the surface
below.
• VOC = 0.21 g/L per EPA Method 24; Vapor Pressure of VOC <0.76
mm of Hg @ 20° C; Meets VOC requirements in all locations.
• For more information, refer to Safety Data Sheet (SDS) online at
www.quikrete.com
WARRANTY
The QUIKRETE
®
Companies, Inc. warrant this product to be of
merchantable quality when used or applied in accordance with the
instructions hereon. The product is not warranted as suitable for any
purpose or use other than the general purpose for which it is
intended. Liability under this warranty is LIMITED to the replacement
of its product (as purchased) found to be defective, or at the shipping
companies’ option, to refund the purchase price. In the event of a
claim under this warranty, notice must be given to The QUIKRETE
®
Companies in writing at One Securities Centre, 3490 Piedmont Rd.,
NE, Suite 1300, Atlanta, GA 30305. THIS WARRANTY IS ISSUED
AND ACCEPTED IN LIEU OF ALL OTHER EXPRESS
WARRANTIES AND EXPRESSLY EXCLUDES LIABILITY FOR
CONSEQUENTIAL DAMAGES.
PRODUCT DESCRIPTION
QUIKRETE
Efflorescence & Rust Remover (No. 8675-33) is a concentrated, water based
formula for removing efflorescence and rust stains from concrete, paver, masonry, brick
and stucco surfaces. The product also restores and enhances the natural color of the
surface prior to the application of
sealers.
DIVISION 3
Maintenance of Concrete
03 01 00
* Refer to www.quikrete.com for the most current technical data, MSDS, and guide specifications

Summary of content (1 pages)