Brochure

BI 7.2.3-40 Sep-2016, Rev 5

Locate and remove the tile that will be replaced by

the tile replacement flashing. Remove tile to the le

of and above the mount location. Locate ra er and

mark center. Measure 8" up from bottom of the

adjacent tiles and mark the location with a horizontal

line across ra er.

Align the base plate over ra er so the lag holes line

up with the ra er line and horizontal line aligns with

the post groove. The orientation of the base plate can

be flipped east-west for post location versatility of up

to 12". Mark location of lag holes on the roof.

Drill two pilot holes using " bit to a depth of 2".

Be sure lags go into center of ra er for strongest

attachment. Pilot holes reduce ra er splitting. Fill

pilot holes with appropriate sealant and align lag holes

over the pilot holes.

Waterproof at underlayment level according to

roofing manufacturer instructions and Tile Roofing

Institute Guidelines.

Insert the grade-8 serrated flange bolt into the bottom

of the post. Slide post into base plate channel. Line

up post with the hole in the tile replacement flashing.

Leave loose for adjustments.

Place the tile replacement flashing over the post

and mount, allowing flashing to interlock with

surrounding tiles properly. Secure the post by

tightening it down using a pair of channel lock pliers.

Replace surrounding tiles.

Use T-30 Torx bit and impact gun to secure mount into

ra er with provided hardware.

Instructions: QMTR - Tile Replacement Mount

Installation Tools Required: stud finder, tape measure, utility knife, drill with " bit, impact gun with T-30 Torx bit, channel lock pliers,

caulking gun, appropriate sealant compatible with EPDM rubber and roofing materials, roofing bar, and hand broom.

NOTE: Installation method is the same for all tile replacement flashing profiles.

WARNING: Quick Mount PV

products are NOT designed

and should NOT be used for

anchoring fall protection

equipment.

Apply a bead of sealant where the post meets the

flashing. Slip the EPDM collar over the post and onto

the flashing.