Installation Guide

19
Copyright © 2019 Ribbon Communications Operating Company, Inc (“Ribbon”). All rights reserved.
Physical Installation
Warning
Caution
Caution
Warning
Installing EdgeMarc 6000 uCPE in a Rack
EdgeMarc 6000 uCPE are of rack mount width. It is not necessary to attach rack
mount ears.
Connecting the Power and Cables
The EdgeMarc 6000 uCPE come with an AC power adapter for connecting to an
AC outlet.
Warning
Always connect the AC power cord to an AC outlet suitable for the power
supply that came with the unit to reduce the risk of damage.
Caution
Secure the AC power cord to a cable management system using a fastener
or tie wrap to insure the EdgeMarc does not hang from the AC outlet.
1. If connecting to an Internet router or Internet DMZ switch, connect the
Ethernet cable to the WAN Interface port (Port 2) on the EdgeMarc and the
other end to the WAN device.
2. Power on the system.
Warning
The equipment has a separate protective earthing terminal on the chassis
that must be permanently connected to earth ground to adequately
ground the chassis and protect the operator from electrical hazards.
Powering On the EdgeMarc 6000 uCPE
1. Turn on the EdgeMarc power switch.
2. Make sure that the power and status LEDs on the front panel are solid green
after the EdgeMarc powers on.
3. Proceed to Chapter 5, Configuring Basic Network Settings.