Installation Manual

1110
INSTALLATION
The following section describes the installation steps for CM1X devices. Vehicle cables and screws
are not included
INSTALLATION
1. Disconnect the vehicle battery main switch, and maintain it disconnected for the duration of the device
installation process.
2. Install the device using bolts on dedicated mounting holes.
3. Guarantee a full contact of bottom cover toward the vehicle with a at surface. CM110 can be placed with no
orientation recommendation. CM100 must be orientated with the top towards the sky to improve the GNSS
internal antenna performance.
4. Guarantee to mount the device in a protected place (e.g. inside the vehicle cabin).
5. Connect the vehicle cables to the device through the connectors.
Ensure that the battery line is protected by a 5A automotive fuse.
CM1X DEVICES INSTALLATION
WARNING - NEVER cover the vent hole in the bottom of the CM1X device
with tape or Velcro. Covering the vent hole may cause device failure, as the
vent hole releases humidity caused by temperature changes.
Mounting
Holes
Mounting
Holes
Vent Hole
12 plus 6 pin
connectors version
12 pin connectors
plus dust cap version