Technical data

Attaching the Power Cord and Turning On the Stacker

To attach the power cord, follow these steps:

1. Connect the socket end of the cord to the power connector on the back of the

DLT2500XT stacker chassis.

2. Plug the other end into a three-pronged (or other approved type) grounded

electrical outlet.

3. At the rear of the unit, turn the stacker on by pressing the side of the On/Off switch

with the “|” as shown in Figure 4-5.

Figure 4-5 Power Switch on the DLT2500XT Stacker

Caution: Always power on the DLT2500XT stacker before powering on the host

system. Always leave the DLT2500XT stacker powered on while the host system is

operational. Failure to follow these procedures can result in SCSI errors on the bus

(see Table 5-4 in Chapter 5).

4. Power on the host system and its console or monitor.

Power switch