Installation Guide

Chapter 3 Installing the Library
Setting Up and Testing the Library
ACL 4/52 Facilities Planning and Installation Guide 25
• Auto clean (enable/disable)
• Retries (enable/disable)
• Exabyte emulation (enable/disable)
• Read barcode labels (yes/no)
• Auto inventory (yes/no)
• Auto load (enable/disable)
These procedures require operator- or service-level security clearance
at the library control panel. For a description of these procedures, refer
to the ACL 4/52 Operator’s Guide.
Performing a System
Test
3
The system test checks out the functionality of all library components.
To run the system test, you must have Service-level access at the
control panel.
Performing an
Inventory
3
The inventory command identifies tape cartridges by reading their bar
code labels and writes their location to nonvolatile RAM. To run the
inventory command, you must have either Operator- or Service-level
access at the control panel.
For more information about this command, refer to the ACL 4/52
Operator’s Guide.