Installation & Assembly

ManualsBrandsQualGear ManualsCeiling Projector Mount Projector MountsPro-AV Universal Ceiling Mount

For a perfect viewing experience, make adjustments

by loosening the screws slightly on the projector mount and

tighten them to secure the position with an allen key.

Roll ±8°, Pitch ±20°, Rotate 360°

Adjustments

CAUTION!

Do not exceed the maximum rated weight

specified. Otherwise, serious injury or

property damage may occur.

32kg

(70lbs)

RATED

Version November 2015

5 Year Limited Warranty

Version November 2015

5 Year Limited Warranty

QG-PRO-PM-50-B

QG-PRO-PM-50-W

HEAVY!

Use an assistant for this step.

IMPORTANT!

Do not loosen screws all the way when making adjustments, this will disconnect the

parts and may cause injury or property damage.

1.5" NPT Pipe

(not included)

Summary of content (4 pages)

PAGE 1
4 QG-PRO-PM-50-B QG-PRO-PM-50-W Adjustments 1.5" NPT Pipe (not included) 20 20 8 8 For a perfect viewing experience, make adjustments by loosening the screws slightly on the projector mount and tighten them to secure the position with an allen key. Roll ±8°, Pitch ±20°, Rotate 360° 32kg (70lbs) HEAVY! Use an assistant for this step. IMPORTANT! Do not loosen screws all the way when making adjustments, this will disconnect the parts and may cause injury or property damage.
PAGE 2
Please read the entire installation manual before you start installation and assembly. y. WARNING  Do not begin to install your QualGear product until you have read and understood all the instructions and warnings contained in this installation manual. If you have any questions regarding the instructions, for US customers please contact QualGear customer support via email at support@qualgear.com. For all international customers, please contact your local distributor.
PAGE 3
1 Connecting the Pipe to the Projector Plate 2 Making Adjustment for Mounting To connect a 1.5" NPT pipe to the projector plate, twist the male threaded end of the pipe into the female thread on the projector plate. Adapter Allen Key (D) 1.5" NPT Pipe Screws (G-2) (not included) gap Front Projector Plate Using allen key (D), insert screws (G-2) to the adapter as shown and leave a gap. Do not tighten all the way.
PAGE 4
Attaching the Projector Mount to the Projector 3 Screws (E/ F/ G-1/ H) Allen Key (C/ D) Projector Plate Washers (I) For screws (E or F) only Click! Projector (not included) Slide projector assembly into the projector plate until you hear a click. NOTE Use washers (I) only when using screws (E or F). Allen Key (D) Depending on your projector, use the appropriate screws (E/ F/ G-1/ H) and then attach the projector mount to the projector and tighten with allen key (C or D).