User's Manual

Roll Door Sensor Installation Verification Installing the Roll Door Sensor

13-14

MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1

Rev. A

4. At the front of the trailer, butt splice the orange and yellow cable wires to the orange and

yellow TT210 system door sensor wires at the TT210 system terminal.

Note

The sensor is a simple switch device; polarity does not matter.

5. Perform the door sensor validation as part of the TT210 system verification (see

Chapter 15: Performing System Verification).

6. If the system verification checks out positively, use sealant around the door sensor

cable where it enters the trailer floor to completely seal the 1/2” hole and around the

magnet and sensor screws to prevent them from coming loose.

7. The roll door sensor installation is now complete.

Orange

Yellow

To TT210 System Mount Assembly

To Door Sensor

06AAA_222

06AAA_219

DRAFT