User's Manual

Testing the Swing Door Sensor Installing the Swing Door Sensor
12-14
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION80-J7615-1
Rev. A
5. Apply adhesive/sealant to the sensor and inside the hole in the door post.
6. Press the sensor all the way into the 1/2" hole until it is fully seated.
7. Wipe off any excess adhesive/sealant.
Testing the Swing Door Sensor
1. Attach an ohmmeter to the sensor wires.
2. Close the door and check the ohmmeter for proper swing door sensor operation.
• When the door is closed, the ohmmeter should measure 0 ohms.
• When the door is open, the ohmmeter should measure an infinite resistance of ohms.
05AAA_22905AAA_229
Adhesive/Sealant
05AAA_207D
Sensor
Wires
Tail light
Assembly
DRAFT