User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 12-9

Installing the Swing Door Sensor Internal Cable Installation Procedure

Internal Cable Installation Procedure

The recommended internal installation procedure is to route the door sensor cable along the

trailer “ceiling” from the trailer nose where the TT210 system mount assembly is located, to

the rear where it will connect with the swing door sensor.

Note

The entire length of the 85-foot cable is covered with convoluted tubing. If there is any excess

cable, cut the excess cable and discard.

Internal Cable Installation Procedure

Note

The actual swing door sensor cable run location will vary between different trailer

manufacturers.

1. Route the 85-foot door sensor cable assembly internally along the inside “ceiling” of the

trailer from the TT210 mount assembly to the swing door sensor location. update

Door sensor cable

in convoluted tubing

To T2

System

Mount Assembly

Orange

Ye l l o w

Sensor

Wires

Cable

Butt

splice

here

Orange

Ye l l o w

Taillight

Assembly

Roof beam

Door sensor

cable

Convoluted

tubing

DRAFT