User's Manual

80-J7615-1 Rev. A MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION 12-5
Installing the Swing Door Sensor Swing Door Magnet Installation
Swing Door Magnet Installation
1. Open the door.
2. Drill a 3/8" diameter x 7/8" deep hole along the horizontal line at the centerline of the
door width.
Note
The 3/8" hole diameter is critical for proper magnet installation.
3. Apply a generous amount of adhesive/sealant into the 3/8" hole in the door.
4. Press the magnet about half-way into the 3/8" hole in the door.
5. Close the door to press the magnet further into the hole.
Centerline of
the door width
Drill 3/8"hole
approximately 7/8" deep
05AAA_235
Door Seal
05AAA_236
Put a light coat of
adhesive/sealant
inside the drilled
hole. Push the
magnet into place.
DRAFT