Owner's Manual
7
TD-000371-00-A
Unpacking
Remove your DXP product from its carton and inspect it carefully. Make sure that the carton contents are complete and that there are no signs of
shipping damage. It is recommended that you keep the original packing materials for reuse in the rare event that service is required. If service is
required and the original packing material is not available, ensure that the unit is adequately protected for shipment (use a strong box of appropriate
size, suffi cient packing/padding material to prevent load shifting or impact damage) or call QSC’s Technical Services Group for replacement packing
material and a carton.
DXP Product Carton Contents
1. DXP
2. Hardware User Manual
3. IEC power cord and wire cord retainer
4. Euro style connector plug kit
Mounting
The DXP product is designed to be mounted in a standard 19" (480 mm) equipment rack and requires 1 vertical rack space (1 RU) (refer to IEC 60297
for additional rack dimensions and design details). Rack mounting provides the DXP with stability and a convenient means for dressing the cables
connecting to the product. Some rack systems also provide climate control and/or conditioned power.
Rack mount the DXP product by supporting it from underneath while aligning the four front panel mounting holes (in the rack ears) with the threaded
screw holes in the rack rails. Install all four mounting screws and washers and tighten securely. The DXP product comes with rear rack support ears.
Ensure that these rear mounting points are securely fastened to rear rack rails or rack side walls.
Confi guring the DXP
DCP Manager™ is used to confi gure the DCP/DXP system. This includes confi guring the device properties, the DSP objects, audio and control I/O
and Presets. The network communications properties and audio networking features can also be confi gured using DCP Manager™. Refer to the DCP
Hardware User Manual for instruction on the installation of DCP Manager, and the DCP Manager™ application Help Files for additional information on
product confi guration, management and network connectivity.
NOTE:
The DXP does not store any confi guration information – confi guration information is loaded from the DCP whenever a valid
control connection is established. Additionally, the DCP will perform any necessary fi rmware updates automatically when it connects to
the DXP.
Once the basic DCP/DXP operating confi guration is defi ned and all of the connections are in place, it’s time to power up the rest of the rack, complete
the DCP/DXP setup, tune the system and run through fi nal check. Refer to additional information in this Hardware User Manual and in the software
Help Files for further setup and confi guration details to complete this step.
Confi guration and Networking Connections
AC Power Cord
Insert the molded receptacle of the AC power cord into the AC power inlet on the back of the DXP product. Plug
the AC line connector into an AC outlet. The power supply on the DXP product will accept from 100 to 240V, 50 to
60 Hz. If a different type of IEC power cord is required than that supplied with the product, consult QSC’s Technical
Services Group.
— Figure 3 —