User's Manual Part 2

60
Basic operations
Set the transducer orientation
Set the transducer orientation
Upon entering all imaging modes, the orientation marker ( ) displays
at the default location (usually at the top left side of the image), and
suggests the operator the direction of holding the transducer. The
orientation marker on the screen corresponds to the position of the
orientation marking on the side of the transducer.
Orientation marker
Figure 14 Transducer orientation (Example transducer-C52A)
The operator can change the left/right orientation of the image (real-
time or frozen) in various imaging (single or dual) without rotating the
transducer head itself.

To reverse left and right
On the imaging screen (real-time or frozen), touch
> L/R.

To reverse up and down
On the imaging screen (real-time or frozen), touch
> U/D.
Adjust the displayed image
On the real-time imaging screen, touch the corresponding mode
selection button to select a scan mode. Use the image control settings to
further optimize the image. For explanations and usage of these settings
on specific modes, please refer to their respective chapters.
The operator can also perform the following operations to adjust the
contents of the imaging window.