Owner`s manual

STEP 1: ASSEMBLE FRONT AND REAR STABILIZERS
Locate 2x M10 Cap Nuts (32), 2x Arc Washers (31), 2x M10 Bolts (30), the Front Stabilizer Bar with
Wheels (8), 4x Allen Screws (33), 4x Washers (42) and the Rear Stabilizer Bar (6)
A. Position the Front Stabilizer Bar with Wheels (8) under the Fan Wheel of the bike and align the
bolt holes to the frame.
IMPORTANT: When aligning these holes, make sure the dimpled, square openings in the Bar are
facing down towards the ground.
B. Attach the Stabilizer Bar to the Main Frame by inserting the bolts up through the Bar. Secure the
bolts rst with the Arc Washers and then tighten the Cap Nuts down to this assembly.
C. Position the Rear Stabilizer Bar (6) behind the Main Frame and attach this to the Main Frame by
lining up the holes in the Rear Stabilizer to the holes in the Main Frame. Secure by rst placing down
a washer (42) to each hole, and then securing 4x Screws (33) to this assembly.
NOTE: The following instructions use the included tools:
Multi-Hex Tool, Small Allen Wrench, and Large Allen Wrench.
Please locate these and keep on hand to assemble.
Meijer.com