User's Manual

Appendix C: Bar Codes Settings
Matrix 2 of 5
EP10 Hand-Held (Windows Embedded 6.5) User Manual C-31
Transmit Check Digit
If the check digit is to be transmitted with the data, this parameter must be enabled.
Set Length L1, Set Length L2, And Set Length L3
Lengths for “Interleaved 2 of 5” can be set from 0 to 255. The length of a code
refers to the number of characters (i.e., human readable characters), including
check digit(s).
Double-tapping on these parameters displays dialog boxes where you can define the code
length that will be recognized by your scanner.
Length Mode
You can chose to set L1 as Minimum Length or L1,L2,L3 as Fixed Length.
Length Restriction
Refer to “Length Restriction” on page C-8 for details.
Add/Remove Data
Refer to “Add/Remove Data” on page C-9 for details.
C.3.15 Matrix 2 of 5
Enabled
Set this parameter to on to enable “Matrix 2 of 5”.
Minimum Length
Minimum lengths for the bar code can be set from 0 to 255. The length of a code refers to
the number of characters (i.e., human readable characters), including
check digit(s).
Length Restriction
Refer to “Length Restriction” on page C-8 for details.
Add/Remove Data
Refer to “Add/Remove Data” on page 9 for details.
Note: French CIP (French pharmaceutical) is only used with bar codes containing 7
characters.
Preliminary Draft