Owners Manual

4865 Sterling Drive, Boulder, CO 80301 . PH: 1 (800) PSAUDIO . www.psaudio.com

Owner’s Reference Sprout100

If you have a CD player, transport, gaming device, or any

digital audio device with a TOSLINK digital output, use a

standard ber optic cable to connect the digital output of

your device to Sprout100’s TOSLINK input as shown in the

back panel diagram. Then select the Digital input on the

front panel.

NOTE* If you have a USB cable connected to the USB input

this will disable the TOSLINK input.

NOTE* The Sprout100 cannot process Dolby Digital inputs.

If taking the output from a Television make sure that the

digital signal is set to PCM.

Sprout100 is equipped with a class 2.0 Bluetooth

transceiver. You will need to select the Bluetooth input

on the input selector to enable this input. Sprout100’s

Bluetooth transmitter will broadcast its ID automatically.

You only need to enable Bluetooth on your device and

select Sprout100 from the available devices.

To use Sprout100 for vinyl, the vinyl input must be

connected only to a turntable. The vinyl input on

Sprout100 was optimized for 5-6mV moving magnet

cartridges and was designed to support moving magnet

cartridges ranging from 3-10mV.

Plug the left and right cables from your turntable into

Sprout100’s input labeled Vinyl. The red vinyl input is right,

the white is left.

NOTE* It is recommended to connect the ground lug to

your turntable if a ground connection is available.

TOSLINK Input

Bluetooth

Input

Vinyl Input

Operating Guide