Maintenance Manual

INSTALLATION AND MAINTENANCE MANUAL
Tsunami FAMILY
FAST ETHERNET WIRELESS BRIDGES
SEPTEMBER 1999
SECTION 3: INSTALLATION & ADJUSTMENTS PAGE 3-7
3.3.6 Frequency Plan Determination
When configuring radios in a hub or repeater configuration, careful engineering of the Tsunami
radio frequency plans and antenna locations should be performed in order to minimize potential
interference between the nearby radios. As a rule of thumb, do not place identical frequency plan
radios (e.g. two “A” channel radios) at the same site. In most cases, it is desirable to use a
different frequency plan (e.g. A versus B). However, with careful engineering, placing more than
one radio of the same frequency channel plan at the same site is easily accomplished. In fact, the
Tsunami frequency plan is designed to allow complex hub configurations that may require re-
using the same frequency plan. When designing these types of configurations, antenna size and
antenna location are critical. If identical channel plans must be used at the same site, the same
radio channel (e.g. A1 and A1) should be used at a site to minimize interference. Using alternate
channels (e.g. A1 and A2) is less likely to be successful (and therefore not recommended) due to
the high level of transmitter to receiver isolation required from the antenna system.
Sometimes it is required to locate the Tsunami radio nearby a transmitter that is the same as, or
close to the Tsunami receive or transmit frequencies. In this case, the Tsunami terminal that
should be placed closest to this interfering transmitter should be the specific terminal with the
receive frequency which is furthest from this unwanted transmitted frequency. This approach
minimizes the potential of interference. While interference conditions are rare when using the
Tsunami radios, cases of interference may be overcome by exchanging the radios from end to
end or simply reinstalling a different filter unit (if applicable), as described in Section 4.2. In some
cases, changing frequency plans (e.g. from A to B) can also help mitigate any interference.
Section 4.8 of this manual describes interference
countermeasures in further detail.