User's Manual Part 1

Tsunami Multipoint Version 1.3 Installation Guide
Figure 23. Subscriber Utility Status Window
Base Station ID
Displays the Terminal ID assigned to the BSU with which the SU communicates.
Operating Status
When the link status between the BSU and local SU changes (for example, when you first power up
the units, change their configuration, and so on) the following status messages appear in this field:
Searching for Outbound
SU searches for an outbound signal (that is, a signal transmitted from the BSU)
Inbound fine sync
Indicates outbound signal detected and the SU is attempting to synchronize with the inbound signal
Link established
Indicates the link is established between the BSU and local SU.
Note: The No connection message indicates that the software is unable to establish a link between the BSU
and local SU. Also, the ODU Not Connected message indicates that the PC used to configure the SU is
not communicating with it. See “Troubleshooting” in the Tsunami Multipoint Version 1.3 Reference
Manual for possible causes and solutions to these problems.
Burst Rate
Shows the current Modulation setting. See “Specify the Desired Modulation (Data Rate)” on page 49
for information.
Chapter 3. Deploying the Subscriber Unit (SU) 37
CPN 63179 Issue Date: 01/24/03