Software Guide

Management
Tsunami
®
800 & 8000 Series - Software Management Guide 220
Figure 6-27 Management Access Control
By default, the Management Access Control feature is disabled on the device. To enable, select Enable from the Access
Table Status box and click OK. Reboot the device, for the changes to take effect.
: Only when the Access Table Status is enabled, you can add host(s) to the Management Access Control Table.
6.5.0.1 Add Host(s) to Management Access Control Table
To add a host to the Management Access Control Table, do the following:
1. Click Add in the Management Access Control screen. The Management Access Table Add Row screen appears:
Figure 6-28 Management Access Table Add Row
2. IP Address: Based on the IP mode, configure either IPv4 or IPv6 address of the host that controls the device
management access.
3. Entry Status: By default, the entry status is enabled meaning which the specified host can control the device
management access. Edit the status to Disable, if you do not want the host to control the device management
access.
4. Click Add.
:
If MAC ACL is enabled, configure at least one entry in the Management Access Table with the IP address (of the PC or
the management station), in order to manage the device.
6.5.0.2 Edit Management Access Control Table Entries
Edit the desired host entries and click OK, COMMIT and then REBOOT.