Software Guide

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 103
Improper configuration of Antenna Gain will affect the sensitivity of the radio card. As the
radar detection threshold is fixed by ETSI, the FCC and IC, any change in sensitivity of the
radio card will result in false radar detections or actual radar signal not being detected. If
the configured antenna gain is higher than the actual antenna gain, Radar signals may
go undetected. If the configured antenna gain is lower than the actual antenna gain,
False Radar may be detected.
Configure the threshold for radar detection at the radio card to compensate for increased
external antenna gains. The Antenna Gain value ranges from 0 to 40 dBi. For devices with
connectorized antenna, the Antenna Gain by default is set to zero dBi.
Given below are the default Antenna Gain, for devices with integrated antenna:
Wireless Inactivity
Timer
Resets the wireless interface if there is no change in the Tx and Rx Packet Count in the
specified interval of time. The default value is set to 5 seconds (disabled if set to 0
seconds) and can be configured between 5 to 600 seconds.
Parameter Descriptions
Product (s) Antenna Gain
MP-8150-SUR
MP-8250-SUR
MP-8250-BS1
23 dBi
MP-8150-SUR-100 21 dBi
MP-8150-CPE
MP-8160-BS9
MP-8250-BS9
16 dBi
MP-825-SUR-50
+
MP-825-CPE-50
MP-8160-CPE-A100
15 dBi
QB-8150-EPR/LNK
QB-8250-EPR/LNK
23 dBi
QB-8150-LNK-100
QB-8151-EPR/LNK
21 dBi
QB-8150-LNK-12/50 16 dBi
QB-825-EPR/LNK-50
QB-825-EPR/LNK-50
+
15 dBi