Operation Manual
AHD DVR User Manual
11
4 Adding IP Cameras (Applicable only for Hybrid Models)
This chapter mainly introduces how to connect multiple IP cameras through NVR. Once you finish adding IP
cameras, you can see the live images through the monitor of the NVR.
To add IP cameras via LAN:
Step 1: Please enter MenuIP Camera tab. Refer to Fig 4-1. Click “Search” button to search the devices in
the same network.
Fig 4-1 Device Management
Step 2: Enter into the search tab. Click “Refresh” to refresh the searched devices. You can modify the IP
address of the searched device by checking the device and clicking “Setup” button.
Fig 4-2 Search Devices
Note: If the network of IP cameras and NVR are in LAN, their IP address must be in the same network
segment. For example: If the IP address of NVR is 192.168.013.057, the IP address of IP camera must
be 192.168.013.XXX.
Step 3: Choose the searched devices and click “OK” button to add these devices. The added cameras will be
listed in the device management interface.
Step 4: Choose the camera device and click “Setup” button to enable the camera. Refer to Fig 4-3. Check
the “enable” checkbox, select channel and input the username and password of this device. Then click “OK”
to save settings.