User manual

5.4.3 Sensor Schedule
This tab allows to set schedule for sensor based recording. The setting steps are as follows:
Step 1: Enter into MenuSetupScheduleSensor interface.
Step 2: The setup steps for schedule for sensor based recording are similar to normal schedule
setup (see Chapter 5.4.1 Schedule for details).
Note: The default schedule of sensor based recording is 24 ⅹ 7. If you want to activate
sensor based recording, you must enable sensor alarm and set up schedule for sensor
alarm (see Chapter 5.5.1 Sensor Alarm for more details).
5.5 Alarm Configuration
Alarm configuration includes four sub menus: sensor, motion, other alarm and alarm out.
5.5.1 Sensor Alarm
Sensor includes three sub menus: basic, alarm handling and schedule.
Operate the following steps to configure sensor alarm:
Step 1: Enter into MenuSetupAlarm SensorBasic tab. Refer to Fig 5-16:
Fig 5-16 Alarm Configuration-Sensor-Sensor
Step 2: Enable channels by checking the checkboxes beside the desired channels.
Step 3: Set the alarm type according to triggered alarm type. Two option: NO and NC.
Step 4: Click “Apply” button to save the setting.
Step 5: Enter into Alarm Handling tab. Refer to Fig 5-17. Select hold time and then click
“Setting” button to pop up a dialog box as shown in Fig 5-18.