Operator's manual and Safety instructions Save This Manual keep this manual Tor the safety warnings preconditions, assembly, operating, inspection, maintenance and cleaning procedures; Write the product's serial number in the back of the manual near the assembly diagram {or month and year of purchase if product has ha number). Keep this manual and the receipt ina gate and dry place for future reference, Back-pack Powered Blower MODEL: PBB2417 A DANGER Using an engine indoors: CAN KILL YOU IN MINUTES.
Table of Content Troubleshooting Specification a Part List and Diagram... sissies Maintenance. WINDOWPANES once WARNING SYMBOLS AND DEFINITIONS This is the safety alert symbol. Ht is used to alert you to oN potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death: Indicates a hazardous stipulation which, if not avoided, lea will result deathlike or serious injury.
Property or Statement Danger. of dismemberment! Never use the machine with he grille:open; Don't put your hand into the volute or tube, Fuel. mixture tank Close the choke Open the choke -“rz The screw under the "HY! stamp is The High-speed mixture adjustment screw. The screw under the "L" stamp is The Low-sped mixture adjustment screw. The screw Up the "stamp.
IMPORTANT SAFETY INSTRUCTION SAVE THESE INSTRUCTION Set up Precautions This manual contain important instructions that should be followed during setup, operation and maintenance of the Blower. 1.Gasoline fuel and fumes are flammable, and potentially explosive, Use proper fuel storage and handling procedures; Do not store fuel or other flammable materials nearby, 2.Have multiple ABC lags fire extinguishers nearby. this equipment. may Create sparks that can start fires around dry vegetation.
starting engine. Always store gasoline in a.container approved for flammable liquids, 8. Work Area. Clear the area of children, bystanders, and peels. Ata minimum; keep:all children; bystanders, and pets outside’a 15:1 (50 ft) radius; outside the 15m (50:11) zone; theirs still a risk-of injury from thrown objects. Bystanders should be encouraged to-wear eye protection. if you are approached, stop the engine. 9. Work from Ladders or on High Surfaces.
mask if operation is-dusty, 24. Use Right Appliance ~ Do not ties appliance for any exception that for which it is intended, 25.Do Not Force Appliance » It will do the job better and with less likelihood of injury-at the rate for which it was designed. 26. Do not Overreach:» Keep proper footing and balance at-all times. 27 Stay Alert Watch what ironware dang. Use cottonmouth sense, Do riot operate appliance when:you are tired.
recurred the equipment on transport vehicles to prevent it from rolling, slipping, landing, 7 Industrial applications must follow OSHA requirements. 8.Do not leave the equipment unattended when: iris running. Turin off the equipment before leaving the work area. 9. Thie equipment can produce high noise levels. Prolonged exposure to noise levels above 85 bass hazardous to hearing. Wear ear protection when operating or when working nearby While it is:operating. 10.
26. Before use, chick for misalignment or binding of moving pies, breakage of parts, and any other condition that may affect the equipment’s operation. if damaged, have the equipment serviced before using. Many accidents are Service Precautions caused by poorly maintained equipment. 27: Use the: correct equipment for the application. Do-not modify the equipment arid do not use the equipment fora:purpose for which it snot intended. 1. Before service maintenance, or cleaning: a.
A Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set Up or use of this'product TO PREVENT SERIOUS INJURY: Operate only with proper spark arrest or installed. Operation of this equipment may. create sparks that can start fires around-dry vegetation: Restorative ay be required.
Assembling Blower Tube and Control Handle 4. Insert the angle tubs info the Flexible hose to thane. Angle Va Tube Flexible: 7 Hose “Ty & Turn the look screw clockwise with the spark plug watchtower tighten the clamp. . Insert the rear tube into the flexible hose lo the end.
Operation Read the ENTIRE IMPORTANT SAFETY INFORMATION section: at the beginning of this manual including alt text under subheadings therein before setup or tse of this product Checking before Starting Inspect engine and equipment locking Tor damaged, loose, and missing parts before set up and starting, If:any: problems: are found, do not use equipment until fixed properly, Checking and Filling Fuel Ak WARNING! TO PREVENT SERIOUS INJURY FROM FIRE: Fill the fuel dank in a ventilated roa away from ignition: s
Hot Start To initiate a Hot Star, follow each step of the Cold Start procedure EXCEPT Sep 8. Stopping the Engine 1: To slop the engine in an emergency aging rotate: the engine switch: counterclockwise fo Switch shit the shine off immediately o 2 Under marital conditions, ke the following procedure Throttle a: Release the Throttle and move: cruise ravel (engine switch) back to idle position. b, Let Engine ile for T= minutes. ©. Crass the Stop Engine Switch.
WARNING TO PREVENT SERIOUS. INJURY FROM ACCIDENTAL STARTING: Turn:the Power: Switch: of the equipment: to its "OFF" position; Walt for the engine to coal and disconnect the spark plug cap before performing any inspection; maintenance; or cleaning procedures. TO PREVENT SERIOUS INJURY FROM EQUIPMENT FAILURE: Do not use damaged equipment.
Id Filling Fuel AA WARNING! TO PREVENT SERIOUS INJURY FROM FIRE: Fill the tubal tank ira well-ventilated takeaway from ignition sources: If the engine is hot from tse: shuttle engine off ang wait for it to.cool before adding fuel. Do riot smoke, fi Clean: the Fuel Tank Copland the ares around it 2. Unstrew and remove the Fuel Tank Gap. Nate: Do not use gasoline containing more than 10% ethanol {E10}. Do not use EBS ‘ethanol Add fuel stabilizer fo the gasoline oF the Warranty is VOID.
Specifications chart. Do notary against the electrode, the spark plug van ba damaged. 5. Stalinist the new: spark plight. or the cleaned spark Plug ditherer engine. + Gasket-style: Frightening until the gasket contacts the cylinder head, then tighten about 12-243 turn more; *Non-gasket style: Fingerstighteruntil:the plug contacts the cylinder head, then skitter about 1/16 tur more: NOTICE: Tighten the: Spark Plug properly.
2. FUEL: To protect the fuel system dinging storage, follow this procedure: a fearfully drain any remaining epithelium fuel tank into inappropriate storage container. impressibility Primer Ult 10 times. ¢ Drain any residue fuel into storage. container: d Sartre: Blower, a Allow engine to fun at idle unt, Blower stalls from flatboat fuel {Replace Fuel Cap and tighten. Ah WARNING! TO PREVENT SERIOUS INJURY FROM FIRE: Drain:the Fuel Tanking well-ventilated Area away from ignition sources.
troubleshooting Problem Possible Causes Probable Solutions Engine will not start FUEL RELATED! 1. Nofuel antitank. 2 Choke not in START position; cold engine. 3 Gasoline with more than 10% ethanol mad. (E16; £20, £86; etc) 4. Low duality or deteriorated, old gasoline loll mixture, 5.
Problem Possible Causes Probable Solutions Engine 'misfires Parker plug cap louse. 2 incorrect spark plug gap ar ravaged spark plug, 3. Defective spark plug cap. 401 of Tow quality gangling rice. Incorrect compression. T. Chack cap and wire connections. br replace spark plug: 3.Replace spark plug cap: 4.08 only. fresh 87+ octal stabilization unleaded gasoline remix. Bono use gasoline with more than 10% ethanol (E15, E20, EBS to) 5. Diagnose and repair compassion.
Parts List and Diagram Part List NO. Description Qty NO Description Oty 1 Starter 1 40. [Cylinder 3 2 drawstring shoat L 41 Muller Basket 3 3 [Screw M5720 4 4a Mer i 4 Steiner hover 4 43 [Muir Giver + 5 [Starter Rope 4 4d. [Sore MESS 2 6 {Asphalt Spring 4 48. sparkler Plug 3 7 Slater Pulley 1 46 |AirdeRenior 4 8 Easy Spring 1 47 gasket 1 G4 Sharer Pawl 1 48: [Morel 4 0 washers 4 49° raunchy barber plug 1 1 Sower 815 1 5. insular 1 12...
years: If any site part including any part that is scheduled only for regular inspection fails during the: period of warranty coverage: twill disrepair replaced at any [BRAND] authorized Service Center at no charge. Any such part repaired or replaced under warranty will be warranted for thermostatic warranty period. A statement to the effect of “repairer replace as necessary” would fot reduce the torpedo of warranty coverage. Any.
Evaporation Emissions Fuel Tank {10) Fel Cay {14 Fueling {12) Fuel Line Filings (18) Clamps®™ (14) Pressure Relief Valvas™™ (16) Tricolor Valves*™ (18) Control Solenoids™ (17) Electronic: Controls™ (18) Vacuums Control Dlaphragms™ Control Cables™ Control Linkages™ Purge Valves Vapor Hoses Liquid/Vapor Separator Carbon Canister Canister Mounting Brackets Carburetor Purge Port Cantor Note: As: they relate to the evaporation emission control system.