Installation Guide

TRIC
RKED
UL
Listed
Electrical
Box
Slide
Mounting
Bracket
Over
Screw
Heads
Ceiling
Mounting
Bracket
Hook
120V
Wires
Mounting
Screws
(Supplied with
Electrical Box)
Close-to-Ceiling
Mounting
Standard Mounting
! !
WARNING
! !
WARNING
! !
WARNING
! !
WARNING
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. MAKE
SURE THE MOUNTING PLATE SLOTS ARE ON
THE LOWER SIDE BY SLIDING THE MOUNTING
BRACKET FROM THE TOP DOWN.
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY, MOUNT
FAN ONLY TO AN OUTLET BOX MARKED
ACCEPTABLE FOR FAN SUPPORT AND USE THE
MOUNTING SCREWS PROVIDED WITH THE
OUTLET BOX.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING. THE TAB IN THE RING MUST REST
IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
THE HOOK AS SHOWN IN FIGURE 11 IS ONLY TO
BALANCE THE FAN WHILE ATTACHING
WIRING. FAILURE TO HANG AS SHOWN IN
FIGURE 14 MAY RESULT IN HOOK BREAKING
CAUSING THE FAN TO FALL. HOOK MUST PASS
FROM INSIDE TO OUTSIDE OF CANOPY.
6
Installing Your Fan To e Electrical Box
Figure 13
Figure 14
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting plate as
shown in Figure 13.
2. Install the ceiling mounting bracket on the
outlet box, by sliding the mounting plate over
the two screws provided with the outlet box
(Figure 13). When using “close-to-ceiling”
mounting, it is important that the mounting
bracket be level. If necessary, use leveling
washers (not included) between the mounting
bracket and the electrical box.
Note that the at side of the mounting bracket
is toward the electrical box (Figure 13).
3. Securely tighten the two mounting screws.
4. If using the “close-to-ceiling” mounting
option, carefully lift the fan assembly up to
the ceiling mounting bracket and hang the fan
on the hook provided by utilizing one of the
holes at the outer rim of the ceiling canopy
(Figure 14). If Using standard mounting,
seat the hanger ball in the mounting bracket
socket. Make sure the tab on the mounting
bracket socket is properly seated in the groove
in the hanger ball (Figure 14).
8002 ∙ 06/23/11 ∙ PCI