User manual

Problem Possible cause Remedy
comes on.
There is an error in the appli-
ance because a cookware
boils dry. The overheating pro-
tection for the cooking zones
and the Automatic Switch Off
operate.
Deactivate the appliance. Re-
move the hot cookware. After,
approximately 30 seconds, acti-
vate the cooking zone again. If
the cookware was the problem,
the error message goes out of
the display, but the residual
heat indicator can stay. Let the
cookware become sufficiently
cool and refer to “Cookware for
the induction cooking zone” to
see if your cookware is compat-
ible with the appliance.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on.
Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
INSTALLATION
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
Built-in appliances
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
Connection cable
• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C;
or higher). Speak to your local Service
Centre.
24 progress