User Manual

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing

materials until you nish all assembly steps.

• After shipping, there may be an oily substance

on the exterior of the treadmill. This is normal. If

there is an oily substance on the treadmill, wipe

it off with a soft cloth and a mild, non-abrasive

cleaner.

• To identify small parts, see page 6.

• Left parts are marked “L” or “Left” and right parts

are marked “R” or “Right.”

• Assembly requires the following tools:

the included hex keys

one adjustable wrench

one Phillips screwdriver

To avoid damaging parts, do not use power tools.

ASSEMBLY

1. To register your product and activate your

warranty in the UK, go to iconsupport.eu. If

you do not have internet access, call Customer

Service (see the front cover of this manual).

To register your product and activate your

warranty in Australia, email or post the

following information to the email address or

postal address on the front cover of this manual.

• your receipt (make sure to keep a copy)

• your name, address, and telephone number

• the model number, serial number, and name

of your product (see the front cover of this

manual)

2. Make sure that the power cord is unplugged.

With the help of a second person, carefully raise

the Uprights (76) to the vertical position.

Next, tighten a 3/8" x 2 1/4" Screw (1) and a

3/8" x 3/4" Screw (24) into the Base (85) and the

right Upright (76) as shown; do not fully tighten

the Screws yet.

Repeat this step on the left side of the tread-

mill (not shown).

Then, tighten all four Screws (1, 24).

This manual downloaded from http://www.manualowl.com