Manual

DIAGRAMOFTHECONSOLE

TheCROSSWALKfeaturesthe innovativeACCUSMART consc,le,_igned Io help you get the mostfrom your work-

outs.The ACCUSMART consoleofferselectronicspeedconirol,finger-touchinclinecontroland a motlvotional illness

monitor with five independentdisplays. Pleaseread theinstructionsbelow before operating the console.

AOI BMAFfl .,.++..o,+0,,

I I

Motivational Fitness Monitor - J J

I I

Baltery Cover

:'_lffD

I I

D_'TAJ_K_

7---1

! I

.Speed'' ' " " Control Knob

_.,/Pulse Earclip Jack

Power Indicator "_Power Switch

Incline Control Lever i _1

+fi

INSTALLING BATrERIES

The motivational illnessmonitor requirestwo "AA" batteries(not

included); alkaline batteries are recommended,slide thebattery cover

open. Grasp the red cord and remove the battery clip from theconsole.

Find the markings insidethe battery clip showingwhichdir_on the

batteries shouldbe turned. Pressthe batteriesintothebattery clip.

Replace the battery clip in the console and close the battery cover.

Battery Cover

+.--+..

BatteryClip

TURNING THE POWER ON

Step onto the foot rails of the CROSS WALK and hold the upper body arms. (SeeOPERATING THE UPPERBODY

ARMS on the following page.) Locate the clip attached by a cord to the safelykey. Slide the clip onto your waistband.

CAUTION: Do not stand on the walking belt while turning the power on. Always wear the clip while operating the

CROSS WALK; if youfall, the safety key will be pulled from the power switch, instantlytumlng the power off.

Insert the safety key into thepower switch.The power indicatorwill light. The five displaysof the motivational fitness

monitor will not light until theON/CLEAR buttonis pressedor thewalking belt begins to move. (See CONTROllING

THE SPEEDOF THEWALKING BELTbelow.) Note: If batteries were just installed,the five displayswill be lighted

already.

CONTROLUNG THESPEEDOF THE WALKING BELT

For your safely, the walking belt will be motionless each iime the power isturned on. To startthe walking belt, first turn

the speed control knob tothe "reset" position. Next, turn the knob slowlyclockwise until the walking belt begins to move

at slow speed. CAUTION: After the knob is turned, there will be a brief pause before the walking belt begins to

move. Adjust the speed slowly until you are familiar with the operation of the CROSSWALK.

Step carefully onto the walking belt and begin exercising.Change the speed o[ the walking belt as desiredby luming

the speed control knob. To stopthe walking belt, turn the knob toIhe 'reset' position.