Manual

MAINTENANCE AND TROUBLE-SHOOTING

Most problems can be solved by following the steps in this section. If further assistance is needed, call

our toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time

(excluding holidays).

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a propedy grounded outlet (see page 8). Use only a single-outlet surge suppres-

sor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor

must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation

of 450 joules. The surge suppressor must be electdcally rated for 120 volts AC and 15 amps.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the con-

sole. See step 1 on page 10.

c. Check the circuit breaker located on the treadmill !i [_

frame near the power cord. If the switch protrudes c

as shown, the circuit breaker has tdpped. To reset Tripped

the circuit breaker, wait for five minutes and then

press the switch back in.

Reset

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing

above). If the circuit breaker has tdpped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console. See step 1 on page 10.

d. If the _eadmill still will not run, please call our toll-free HELPLINE.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Check the batteries in the console. See BATTERY INSTALLATION on page 9. Most problems

are the result of drained batteries.

b. Remove the six screws from the hood. Carefully re-

move the hood. Locate the Reed Switch (45) and

the Magnet (44) on the left side of the Pulley (49).

Tum the Pulley until the Magnet is aligned with the

Reed Switch. Make sure that the gap between the

Magnet and the Reed Switch is about 1/8". If nec-

essary, loosen the Screw (53) and move the Reed

Switch slightly. Retighten the Screw. Re-attach the

hood, and run the treadmill for a few minutes to

check for a correct speed reading.

118" _ .,L

Top

View