Owner's Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Assembly requires your own Phillips screw-

driver , wire cutters , and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the

treadmill to the upright position.

While a second person tips the treadmill to one side

slightly and holds it, insert one of the Extension Legs (103)

into the treadmill as shown. Make sure that the Extension

Leg is turned so the Base Pad (97) is on the bottom.

Next, tip the treadmill to the other side and insert the

other Extension Leg (not shown) in the same way. Lower

the side of the treadmill so that both Extension Legs

(103) are resting flat on the floor. Cut the wire tie off the

Upright (82).

2. With the help of a second person, carefully lower the

treadmill frame and then tip the Uprights (82) down as

shown. Make sure that the Extension Legs (103) re-

main in the Uprights.

Attach each Extension Leg (103) with two Screws (101)

and a Base Pad (121) as shown.

Note: One replacement Base Pad (121) and Spacer (not

shown) may be included. If a Base Pad becomes worn

and needs to be replaced, use the replacement Base

Pad. If a Thick Base Pad (97) needs to be replaced, use

the replacement Base Pad with the Spacer.

103

101

121

101

103

3. With the help of a second person, carefully tip the

Uprights (82) back to the vertical position.

Attach the Latch Assembly (9) and the Latch Spacer (56)

to the left Upright (82) with two Screws (101) as shown.

101

Wire Tie

101