User`s manual

12. Orient the Right Upper Body Arm (5) so that

the indicated tube is facing inward. Lubricate

the upper end of the right Upper Body Leg (6)

with high-temperature lubricant. Then, slide

the Right Upper Body Arm onto the Upper

Body Leg.

Apply a small amount of grease to a Wave

Washer (27). Then, insert the Pivot Axle (16)

through the Wave Washer, the remaining

Upper Body Arm Spacer (29), and the Right

Upper Body Arm (5).

13. Apply a small amount of grease to each end

of the Pivot Axle (16). Slide an M8 Large

Washer (81) onto an M8 x 25mm Patch Screw

(70), and tighten the Patch Screw into the left

end of the Pivot Axle. Then, press a Pivot

Cover (14) against the Left Upper Body Arm

(4).

Repeat this step for the Right Upper Body

Arm (5).

14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

Tube

Grease

Lubricate