User's Manual

Peel the backing off one of the included plastic anchors

(L). Press the plastic anchor onto the console plate (M)

in the indicated location.

Fold the speaker wire (J) as shown and secure it to the

plastic anchor (L) with a plastic tie (N).

Before beginning installation, lay all parts in a cleared area and remove the packing materials. Do not dispose of

the packing materials until installation is completed. Included in this kit are ten 1/2” screws and eight long

screws. For your convenience, separate the screws into two piles before beginning installation.

Installation requires a phillips screwdriver .

How to Install the Speakers

Attach the right speaker bracket (A) to the right

upright (B) with four of the long screws (C). Next, peel

the backing off the fastener strips (D).

Identify the right speaker (E) (refer to the front of this

guide). Press the right speaker firmly onto the fastener

strips (D), with the back of the speaker resting against

the back of the speaker bracket (A).

Attach the left speaker bracket and the left speaker in

the same way (not shown).

Remove the four 1/2” screws (F) and the six 3/4”

screws (G) from the back of the console (H). Discard

the screws.

Remove the back of the console (H).

Locate the audio wire (I) beneath the console. Plug the

audio wire into the INPUT jack on the right speaker.

Locate the speaker wire (J) attached to the left speaker.

Plug the speaker wire into the SPEAKER OUT jack.

Next, plug one end of the jumper wire (K) into the DC

IN 15VDC jack. Plug the other end into the jack on the

right upright.