User's Manual

ASSEMBLY

ssembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not

dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench ,

a phillips screwdriver and scissors (not included) .

1. Refer to the drawing on page 4 and identify the right

side of the treadmill. With the help of a second person,

carefully lay the treadmill on its right side; do not lay the

treadmill on its left side or the storage latch may be

damaged.

Firmly slide a Base Extension (76) into one side of the

Base (86). Using the Allen Wrench (89), tighten an

Extension Bolt (13) into the Base Extension and the Base.

While the treadmill is on its side, attach the other Base

Extension (not shown) in the same manner.

2. Attach six Base Pads (43) to the Base (86) and the Base

Extensions (76) in the indicated locations. Note: One

extra Base Pad may be included.

With the help of a second person, carefully raise the

treadmill to the upright position so the Base (86) and the

Base Extensions (76) are resting on the floor.

Refer to HOW TO LOWER THE TREADMILL FOR USE.

Follow the instructions to lower the treadmill.

3. Cut the two Shipping Ties from the Handrails (61).

4. Remove the four Handrail Bracket Screws (15) from the

right side of the Frame (83). Position the

right Handrail

Bracket (42) over the four screw holes in the Frame.

Loosely thread two of the Screws into the back holes of

the Bracket and into the Frame as shown.

Repeat this step on the left side of the Frame (83).

Shipping

Ties