Specification Sheet

ManualsBrandsPROFLO ManualsPlumbing60" x 60" Whirlpool Bathtub with 8 Hydro Jets and EasyCare Acrylic - Drop In or Corner Alcove Installation (Left Hand Pump)

Product Features

• Durable easy-care acrylic

construction

• Eight fully adjustable color

matched hydro jets

• High efficiency 5.6 amp/.8 HP motor

•

Factory preset air controls for

whirlpool action

• Textured slip resistant bottom

• Air activated on/off switch

• Available as an invigorating

whirlpool and an unjetted

soaking bath

General Specifications

• 60” side length

• 21” depth overall

• 60” side width

• 72 gallon operating capacity

• 109 gallon total capacity to

overflow

• Electrical service requirements:

Motor 120 V., 10.5 A., 50/60 Hz.,

Single Phase, Class B Insulation

• Ground fault circuit protection

must be provided by installer

• Prewired for simple plug-in

installation

PFWPLUSAL6060WH

60 x 60 Plus A Series

Whirlpool & Soaking Baths

Model Numbers

PFWPLUSAL6060 60” x 60” LH corner whirlpool

PFWPLUSAR6060 60” x 60” RH corner whirlpool

PFS6060 60” x 60” acrylic corner soaking bath

PFSK6060 Removable apron

PFTLKC Tile flange kit for 60” x 60”

MIRPRESSHTR Whirlpool heater

NOTE: Choose left hand or right hand based on desired pump location.

Product Specifications

Shown with optional removable panel apron

Color Palette

• White

• Biscuit

Recommended Parts

PF1641 PVC/ABS 17”-22” Tub depth

PF1642 PVC/ABS 23”-27” Tub depth

Warranty and Codes

This product features a 5-year limited warranty

and meets or exceeds the following standards:

Whirlpools - IAPMO PS32-84, UL listing 27E7, ANSI

Z124.1-95, ASME A112.19.8M-87R(96) and ASME

A112.19.7M-95. Baths - ANSI Z124.1-95. In an effort

to continually improve our products, design changes

may periodically be made. Ferguson reserves the

right to provide newly designed material to fill any

order unless otherwise agreed to in writing.

NOTE: All dimensions and specifications are nominal and may vary

⁄4

”.

Use actual products for accuracy in critical situations.

Installation Instructions

Never allow the weight of the tub to be supported by lip on deck or stringers, as this could result

in product failure and void the Warranty. If utilities are available, level and fill tub with water and

test for proper operation and drainage or possible water leaks due to transit/handling damage.

It is REQUIRED that the tub be supported by the tub bottom and not the tub lip. The lip should

only rest on the finished deck surface or support stringers. The tub bottom must be supported

by a setting compound such as cement or mortar (fast cure materials are not recommended

due to excessive shrinkage). Failure to use a suitable setting compound will void the warranty. A

sheet of plastic film on top of compound, is recommended as a barrier. The tub should be set in

place (do not handle whirlpool by piping) while compound is still soft so that the compound will

conform to the tub bottom. Tub should be worked down into compound so the lip of the tub just

makes contact with finished deck surface or support stringers. It may be necessary to partially

fill tub with water to aid in properly setting the tub.

Distributed Exclusively by Ferguson and Wolseley Canada