Instructions / Assembly

1
Mark the installation area and
trench approximately 3" deep
along the border. Place edging
in trench, with no more than
½" - 1" of the edging showing
above ground.
2
Secure the edging with anchoring
spikes (included in kit). Use a
rubber mallet to drive spikes
through the pre-drilled holes into
the soil at an angle.
3
Backll with soil on both sides of
the edging. Compact soil to secure
the edging and cover with mulch
or stone. Ground cover material
should ll to the top of the edging.
-
HOW TO CONNECT:
An overlapping connection
system is used to adjoining
edging pieces. Slide ends of
edging strips together to
connect pieces prior to placing
in the ground. For best results,
overlap pieces 2 - 4 inches.
HOW TO CUT:
Carefully cut edging sections
to the desired length using a
hacksaw. Always take proper
safety precautions when cutting,
including wearing protective
eyewear.
INSTALLATION INSTRUCTIONS
INST-PALM-RV0
HELPFUL TIPS
GRADE CHANGES:
Cut a “V” shaped notch in the bottom of
the edging and bend to accommodate
the slope.
CREATE CORNERS:
Bend the edging around a 2x4 piece of
wood or other solid object to achieve the
desired angle.
CREATE CURVES:
Aluminum edging bends easily to create
curves as needed. Carefully bend the edging
to t the landscape design. Aggressive bends
can cause kinks in edging.
ANCHORING SPIKES:
Anchoring spikes are included in most kits.
Supplementary spikes kits are sold separately.
RECOMMENDED
TOOLS:
• Spade or shovel
• Rubber mallet
• Hacksaw
• 2x4 piece of wood
• Protective eyewear
Questions/Comments? Contact us at
[e-mail]