ITEM #0011258 MANUAL ON/OFF VALVE SAFETY PILOT KIT MODEL # NVDWA1 Español p. 11 Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-573-0674, 8:00 a.m - 4:30 p.m., EST, Monday - Friday or e-mail customerservice@usaprocom.com.
PACKAGE CONTENTS D C G H L I A J K M O B F N Part A B C D E F G H I J K L M N O Description Propane/LP Burner Air Mixer Gas Control Valve Safety Pilot Pilot Gas Pipe Assembly Control Knob Control Rod Extension 18 in. Propane/LP Orifice 24 in. Propane/LP Orifice 30 in.
WARNINGS AND CAUTIONS WARNING • If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life. • Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or additional information consult a qualified installer, service agency, or the gas supplier. • This appliance requires a 1/2 in.
NATURAL GAS INSTALLATION 1. Thread the gas control valve (B) onto the burner air mixer (A). Use pipe sealant on the male threads of the burner air mixer. Hold the burner air mixer with a wrench to prevent overtightening the connection to the burner. Make sure the control rod is facing the front as shown in Fig. 1. Fig. 1 A B 2. Attach the pilot gas pipe assembly (D) to the safety pilot (C) outlet of the gas control valve (B) and tighten.
Fig. 4 4. Install valve cover (L) to burner pan using two self tapping screws (K) as shown in Fig. 4. K L 5. Install safety pilot (C) and piezo ignitor (M) onto valve cover (L) as shown in Fig. 5. Use two self tapping screws (K). Fig. 5 C K L M Fig. 6 6. Install the control knob (E) to the control rod extension (F). Push the control rod extension (F) onto the “D” shaped control rod through the center hole in the cover as shown in Fig. 6.
7. When installing this kit on the left hand side of the burner, adhere control instruction label (N) onto valve cover (L) as shown in Fig. 7. Fig. 7 L OFF N PROPANE/LP GAS INSTALLATION Fig. 1 1. Remove the natural gas burner inlet fitting from the burner pan assembly as shown in Fig. 1. DO NOT remove the orifice from this fitting. If you have a 24 in. log set, then the 24 in. propane/LP orifice (H), shown in the table below, is already installed in the propane/LP burner air mixer (A).
The number stamped on orifices correspond to each respective size log set as indicated by model numbers as shown in table below. Model # SSEAV18RP SSEAV24RP SSWV24RP SSWV30RP Orifice G H H I Orifice # 18 24 24 30 For an 18 in. or 30 in. log set, use a 10 mm socket or nut driver to remove the orifice from the propane/LP burner air mixer (A). 3. Using pipe sealant on the thread of the larger end of fitting, screw the propane/LP burner air mixer (A) through hole and into burner manifold as shown in Fig. 3.
REPLACEMENT PARTS NOTE: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS UNDER WARRANTY Call Customer Service toll free at (1-866-573-0674) for referral information.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-866-573-0674, 8:00 a.m - 4:30 p.m., EST, Monday - Friday or e-mail customerservice@usaprocom.com. Part. A B C D E F G H I J K L M N O Description Propane/LP Burner Air Mixer Gas Control Valve Safety Pilot Pilot Gas Pipe Assembly Control Knob Control Rod Extension 18 in. Propane/LP Orifice 24 in. Propane/LP Orifice 30 in.
2-YEAR LIMITED WARRANTY The manufacturer warrants this product to be free from defects in workmanship and material present at time of shipment from the factory for two (2) years from the date of purchase. This warranty applies only to the original purchaser. The manufacturer agrees to correct such defect at no charge or, at our option, replace the product with a comparable or superior model. To obtain warranty service, call our customer service department at 1-866-573-0674.
