Instruction manual

7
1. Loosen the 1.5mm setscrew connecting the drive shaft to the
motor coupler.
2. Loosen the 1.5mm setscrew connecting the universal joint to
the drive shaft.
3. Remove the two 3mm screws from the outdrive to separate
the rudder assembly from the mount. Make sure not to lose the
3mm nuts when removing the screws.
4. Move the rudder assembly and slide the drive shaft out of the
stuffing box.
5. Lubricate the drive shaft with PRB0100 Marine Grease. Reinstall
the drive shaft in reverse order. Be sure to reinstall the nylon
washer between the universal and the stuffing box.
Note: Running the Apache 24 EP RTR in salt water could cause
some parts to corrode. If you run the boat in salt water, rinse
it thoroughly in fresh water after each use and lubricate the
drive system.
Section 9: Lubricating the Drive Shaft