User Manual

Vertical Tracking Force setting (VTF)

* This setting is only neccessary when you decided to repalce your cartridge. For factory fitted cartridge,

VTF was perfectly pre-set already.

Before setting the Vertical Tracking Force, confirm the exact weight of your cartridge.

Pushing carefully, move the counterweight

onto the rear end of the counterweight support rod. Place the

stylus pressure gauge onto the platter. To set the required VTF, lower the tonearm lift lever as indicated in

the illustration and place the tip of the stylus exactly in between the two points marked 15mN and 20mN.

If the stylus gauge becomes level, then the correct pressure has been achieved. However, if the there is

insufficient or excessive pressure the gauge will either not move or tilt down. Moving the counterweight

(6) away from the cartridge will reduce pressure and towards will increase pressure. Finally secure the

counterweight (6) using hexagonal key provided.

Speed control

The turntable is equipped with a three-position switch for ON/OFF and electronic speed change. To play

records at 33 r.p.m. press the switch (16) to the front side to position no. 1. To play records at 45 r.p.m.

press the switch (16) to the rear side to position no. 2