Assembly Instructions

[phone]
Primo Countertop Cypress Table Assembly Instructions
www.primogrill.com
ASSEMBLY INSTRUCTIONS
Hardware bags are attached to the underside of
bottom shelves.
There are 4 blocks of wood attached to the
ends of the Table Top Assembly. These
blocks are for shipping purposes and should
be carefully removed from the Table Top
Assembly.
There are 2 different leg assemblies which must
be placed in the correct position. Place the leg
assemblies so the locking casters face front of
the table.
1. Find the Grill Shelf Assembly and attach to the
Left Side Assembly (bottom hole is
approximately 9” from caster) with 2 ½”
carriage bolts, washers, and nuts.
2. Attach Center Support Assemblies with three
holes (this assembly is 2 separate pieces) to
the other end of shelf using middle hole with 2
½” carriage bolts, washers, and nuts.
3. Attach the Side Shelf Assembly to same
Center Support Assembly using bottom holes
and the 2 ½ ” bolts, washers and nuts.
4. Attach the Right Side assembly to opposite
end of the Side Shelf Assembly with 4 ½”
bolts, nuts and washers. Snug nuts hand tight
at this point. Stand table upright.
5. Place Table Top Assembly on top of legs
aligning holes in the cross support boards
using 2 ½” bolts, nuts, and washers. Make
sure the hole in the top of the table is above
Grill Shelf Assembly. Tighten all nuts until bolt
heads start to impact wood.
6. Align 4 Ceramic Shoes as shown on the Grill
Shelf. Protect the table top with towels or
cardboard from the carton and carefully lower
Primo Ceramic Grill into place. Adjust Ceramic
feet as necessary for best stability.
CARE INSTRUCTIONS
We want to make sure your table stays beautiful
and distinctive throughout the years.
To properly care for your table, please make sure
to use a standard sealant (Marine or Spar
Varnish). This product is available at most paint
or hardware stores. The first application should
be more than one coat. The more coats the better
you will protect your table. NOTE: STAIN IS NOT
a sealant. Reseal as needed in the future.
If lifting the table, DO NOT lift your table by the
top shelf.
TOOLS REQUIRED FOR ASSEMBLY:
ADJUSTABLE WRENCH OR 13MM WRENCH OR EQUIVALENT
HARDWARE
SUB-ASSEMBLIES
PART NUMBER: #621 (FOR OVAL XL 400), #613 (FOR OVAL LG 300) & #614 (FOR JR 200)
FOURTEEN (14)
NUTS
FOURTEEN (14)
WASHERS
TWELVE (12) 2 1/2"
CARRIAGE BOLTS
TWO (2) 4 1/2"
CARRIAGE BOLTS
TABLE TOP
ASSEMBLY
(614 TOP PICTURED)
LEFT SIDE
ASSEMBLY
CENTER SUPPORT
ASSEMBLIES
RIGHT SIDE
ASSEMBLY
4 CERAMIC SHOES
GRILL SHELF
ASSEMBLY
SIDE SHELF
ASSEMBLY
1
3
2
4
5
6
FINISHED ASSEMBLY
(614 TABLE PICTURED)