Operation Manual

9
Example:
Configuration
You are in Channel 22, FM.
- Short press on «MODE»:
set goes to Channel 22 AM.
- Longer press on «MODE»:
set goes to Channel 22 FM
then 22 LSB.
- Short press on «MODE»:
set goes to Channel 22 USB.
- Longer press on «MODE»:
set goes to Channel 22 LSB
then 22 AM.
8) RF POWER:
When you turn this knob fully clockwise the RF power (norm peak 4 watts) is at
maximum. You should reduce transmission power when the communication
is close to someone who does not have RF GAIN.
The normal setting of this knob is on maximum (fully clockwise).
9) RF GAIN:
This knob is for adjusting sensitivity during reception. For long distance
communications RF GAIN should be set to maximum. RF GAIN can be
reduced to avoid distortion, when your correspondent is close by and when
he does not have RF POWER.
The normal setting of this knob is on maximum (fully clockwise).
10)MIC GAIN:
a) Is for regulating microphone sensitivity, when using a microphone other than
the one supplied with your PRESIDENT GEORGE. (pre-amplified).
b) Also adjusts the sound volume of Public Address mode (see point 17).
The normal setting of this knob is fully clockwise.
11)CLARIFIER:
This function allows a frequency deviation during LSB/USB reception to improve
the clearness of your correspondent’s voice. This allows a shift of up to 2 kHz
around the reference frequency.
The normal setting of this function is fully clockwise.
12)SWR/CAL:
Used for the calibration of the SWR meter (see «Adjustment of SWR» page 7,
§ 5).
13)HI-CUT:
Cuts out high frequency inter-ference. Its use depends on reception conditions.
Depress the key to use this function, «HICUT» appears in the display. To cancel,
press the same key, «HICUT» disappears from the display.