Installation Guide

6.
4.
2b.
INSTALLATION STEPS: Single handle kitchen faucet
1.
5.
3.
2a.
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
Model Number: 120097 & 120098
INSTALLATION
Escutcheon Installation (optional).
Place escutcheon and base plate on
bottom of new faucet. Place faucet
through mounting holes in sink. Secure
faucet to sink using washer (1) and nut
(2) provided.
Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
Flange Installation (optional).
Place flange on bottom of new faucet. Place
faucet through mounting holes in sink.
Secure faucet to sink using washer (1) and
nut (2) provided.
For models with spray:
Insert spray support through far right hole
on sink. Screw hold - down nut onto shank
and hand tighten.
For models with spray
Insert spray hose down through support and
sink. Attach spray hose to spray hose nipple.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2,
not included), or use the coupling nuts (3,
not included) with a 3/8 in. O.D. ball-nose
riser (1, not included). Use wrenches
when tightening. Do not overtighten.
NOTE: The hot side inlet tube is indcated
by a label.
2
3
1
1
2
1
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty