Installation Guide

INSTALLATION STEPS: Single handle bar faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Model Number: 120347LF & 120348LF & 110703
Place new faucet hoses and thread rod
through the center hole of sink.
3.
Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
1.
Install cover plate (optional).
Place base plate (2) and cover plate (1) on
the sink. If you do not use the cover plate,
please use flange (3) and seat (4) to replace
cover plate and base plate.
2.
From underside, assemble rubber washer,
metal washer, and mounting nut onto the
thread rod and tighten mounting nut. Do
not overtighten.
4.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser
(1, not included). Use wrenches when
tightening. Do not overtighten.
NOTE: The hot side inlet tube is indcated by
a label. If the label is not present, the hot
supply tube is the longer of the two inlet
tubes.
5.
3
1
2
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
6.
3
4
1
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty