EH1442 2 kW Mica Column Heater 2 Heat settings Electronic thermostat with remote control Built-in carrying handle Durable Castors Safety overload cut-out Cable storage feature Page 1
IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. BEFORE USE You must inspect the appliance including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately. INSTALLATION Attaching the feet and castors. Turn the appliance upside down and hold it steady. Slide the foot into the base of the appliance adjacent to the mains cable entry.
The digital display will display the room temperature. The up- and down-arrow buttons can be used to select full power or half power. This is indicated by the segments to the right of the flame symbol. Small segment lit = half power. Both segments lit = full power. To set the thermostat press the TEMP button, then press the up- or down-arrow buttons to change the target temperature. The thermometer symbol will illuminate, and the digital display will flash, showing the target temperature.
PRODUCT SAFETY • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Children should be supervised to ensure that they do not play with the appliance • Place the appliance on a firm flat surface.
PAT TESTING When used in an office environment, this product must be safety-tested yearly by a qualified electrician (PAT Tested) in order to comply with the Electricity at Work Regulations. We recommend that it is PAT tested regularly when used in a domestic environment. GENERAL SAFETY REQUIREMENTS Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at every change of occupancy.
If the mains lead is damaged, it must be replaced by the manufacturer or and authorised service centre. If the mains plug needs to be replaced, proceed as follows: • Connect the brown wire to the terminal labelled "L". • Connect the blue wire to the terminal labelled "N". • Connect the green/yellow wire to the terminal labelled with the earth symbol or "E". • Make sure that the cord-grip is positioned correctly (over the outer sheath of the cable) and it fully tightened.
FAULT-FINDING If the appliance is not operating, proceed as follows: Check that the mains plug is firmly in the socket, and that the socket is switched ON. Check that at least one of the power control switches is switched ON. The appliance also has a overload protection device to prevent overheating. If this operates, disconnect the appliance from the mains supply, and remove any objects on or adjacent to the appliance that could have caused the overheating.
TECHNICAL SPECIFICATION Dimensions: Weight: Power supply: Power consumption: Operating current: 617×121×644 mm 6.3 kg 230 V ~ 2000 W 8.7 A SERVICE WARRANTY Prem-i-Air guarantees the product free from defects in materials and workmanship for a period of two years. Should this appliance be operated under conditions other than those recommended, at voltages other than the voltage indicated on the appliance, or any attempts made to service or modify the appliance, then the warranty will be rendered void.