User's Manual

6WDUWXSDQG&RQILJXUDWLRQ
 WLDM001B
3. Perform a soft restart of the radio terminal for the changes to
take effect:
– Select
7HUPLQDO
→
6WDWH&RQWURO
and select Restart type
=
6RIW
.
– Wait until the radio terminal is in STANDBY state.
4. Go to the web page "Address Configuration" (
1HWZRUN
→
,3
$GGUHVVHV
) to verify the changes above.
5. Go to the web page "Network Interface Configuration"
(
1HWZRUN
→
,QWHUIDFHV
) and make sure that the status of the
ECC port is set to "Up".
6. Exit the web browser and disconnect the serial PC cable
between the local PC and the radio terminal.
7. Make sure the remote management equipment is connected
to the ECC, and that it is set up to work properly in its
environment. For further information, refer to the Operation
and Maintenance Manual (WLDM002).
8. Proceed to section
$QWHQQD$OLJQPHQW
on page 80.