User's Manual

6WDUWXSDQG&RQILJXUDWLRQ
 WLDM001B
&RQQHFWLQJYLD0RGHP
1. Allocate an IP address to the serial port (MODEM/NMS 2) of
the radio terminal in one of the following ways:
– For set-up of a TCP/IP network on a modem connection
using static IP addresses, allocate a static IP address,
subnet mask and broadcast address to the serial port
(MODEM/NMS 2). Refer to section
$OORFDWLQJ6WDWLF,3
$GGUHVV
on page 78.
– For set-up of a TCP/IP network on a modem connection
using dynamic IP addresses, configure the serial port
(MODEM/NMS 2) to use dynamic IP addresses. Refer to
section
$OORFDWLQJ'\QDPLF,3$GGUHVV
on page 79.
2. Configure the serial port (MODEM/NMS 2) for modem
connection by selecting
1HWZRUN
→
6HULDO,QWHUIDFHV
and
editing the following parameters:
3. Configure the modem behaviour for the serial port (MODEM/
NMS 2) by selecting
1HWZRUN
→
6HULDO,QWHUIDFHV
and
editing the following parameters:
– Telephone number;
– Modem mode; and
– Modem idle timeout.
,QWHUIDFH %DXGUDWH 8VDJH
RS-232/2
6HOHFWWKH
EDXGUDWHWRXVH
6HOHFWWKHFRQQHFWLRQW\SH
([WHUQDOPRGHP