User's Manual

6WDUWXSDQG&RQILJXUDWLRQ
 WLDM001B
6. Allocate an IP address to the serial port LM/NMS 1 of the
radio terminal by executing the command
VHWLS  LSDGGUHVV!
where
LSDGGUHVV!
is the desired IP address.
7. Allocate a subnet mask to the serial port by executing the
command
VHWQP VXEQHWPDVN!
where
VXEQHWPDVN!
is the desired subnet mask (default =

).
8. After you have changed the system settings according to step
9–10 above, you must restart the terminal for the changes to
take effect. Execute the command
UHVWDUWVRIW
and wait until the terminal is ready and idle again.
9. Log in and use the command
LSFRQILJ
to verify that the commands in step 9–10 above were
successfully executed. This command will return the current
IP addresses for the ports of the radio terminal.
10. Exit the HyperTerminal program and close the connection.
11. Proceed to section
'LDOOLQJ8SYLDWKH6HULDO3RUW
below.