User's Manual
Table Of Contents
- Installation Manual
- Contents
- Introduction
- Site Requirements
- Indoor Installation
- Tools Required for Indoor Installation
- Indoor Equipment
- Indoor Accessories
- Baseband Unit
- Traffic Interface Unit
- Mounting the Indoor Unit
- Grounding the Indoor Unit
- Installing the Cables for the Indoor Unit
- Outdoor Installation
- Tools Required for Outdoor Installation
- Outdoor Equipment
- Choosing Vertical or Horizontal Polarization
- Integrating Antenna Unit and Radio Frequency Unit
- Choosing Left or Right Side Antenna Mounting
- Fastening the Mast Mounting Bracket
- Mounting the Integrated Antenna/Radio Frequency Unit
- Grounding the Antenna/Radio Frequency Unit
- Outdoor Radio Cable Installation
- Start-up and Configuration
- Antenna Alignment
- Installation Verification and Test
- Index
,QGRRU,QVWDOODWLRQ
WLDM001B
7UDIILF,QWHUIDFH8QLW
All traffic interfaces are located on the TIU of the Indoor Unit. The
interfaces are compliant with ITU-T G.703. Two different types of
interfaces are available:
• Unbalanced interface: SMZ connector, 75 Ω.
• Balanced interface: 9 pin or 37 pin D-SUB connector,
120 Ω (E1) / 100 Ω (DS1).
• Ethernet standard interface: RJ-45 connector.
9
Sofix
1
/Metral
2
connectors
Used for connection of the TIU.
1. Ericsson designation
2. Berg designation
&$87,21
:KHQPRXQWLQJ WKH7,8LQWKH%%8 WKHWZRVFUHZVPXVW EH
IDVWHQHGE\KDQG'RQRWXVHDQ\WRROVRUH[FHVVLYHIRUFH
3RV ,QWHUIDFH )XQFWLRQ